How to elasticate a pole top kit

Elasticating your pole top kit can be quite a daunting task especially if it is the first time of doing it. Well you need not to worry any longer as we have a very simple step-by-step guide for you to follow that will allow you to elasticate your top kit in no time. 

First, cut back the tip section of the pole a few inches at a time with a hacksaw until the PTFE bush fits snugly. Smooth the cut edge with sandpaper.

Now fit the PTFE bush. Some people like to use glue to achieve a permanent bond.

Slot the pole bung into the top kit and cut back the excess bung sticking out of the section, leaving enough space for the next section to fit.

Thread elastic through the top kit and tie off the bung end with figure-of-eight knot. Replace the bung and pull it tightly into place via the elastic.

The easiest rig connector is a plastic Stonfo, but some anglers like Dacron connectors or a figure-of-eight crow’s foot knot with trimmed-off ends.